It’s normal to get error codes and messages when using Phantom 4 and it’s better to get some knowledge about those things and how to fix those issues. I went through many DJI forums and collected several error codes and how to fix them.
Hope this article would help with solving your Phantom 4 Error codes. Below, There is the list of error codes I was able to collect from DJI forums.
Common DJI Phantom 4/ 4 Pro Error Codes.
- Error 1: DJI Phantom 4 Error Code 50 (IMU Error).
- Error 2: DJI Phantom 4 Battery Error.
- Error 3: DJI Phantom 4 ESC Status Error.
- Error 4: DJI Phantom 4 Compass Error (COMPASS-ERR).
- Error 5: DJI Phantom 4 GPS Error.
- Error 6: DJI Phantom 4 Camera Sensor Error.
Error 1: DJI Phantom 4 Error Code 50 (IMU Error).
Phantom 4 Error Code 50 is an IMU calibration error and many Phantom 4 users get this error because of performing the calibration process near metal structures while calibrating the IMU. Also outdated Phantom 4 firmware, and glitched firmware also could cause the issue.
Solutions.
- Update Phantom 4 firmware. Outdated firmware and firmware glitches can mess up the IMU calibration process. Therefore make sure to keep the firmware updated when you perform any calibration. Read How to Update DJI Phantom 4 firmware if you need to.
- Perform the IMU calibration process in a proper environment. When calibrating IMU you need to pay attention to the surroundings. For example, you should perform the process on a flat surface and should keep metal and electronics away from the aircraft. Also, you should perform the steps properly. Read the How to Calibrate IMU article for a detailed explanation of IMU calibration.
- Factory Reset Phantom 4. Download and install DJI Assistant 2 application to the PC. Connect Phantom 4 aircraft to the PC. Open the DJI Assistant 2 application and log in to your DJI account and choose Phantom 4. Then go to the “Firmware Updates” tab and click on “Factory Reset”.
- Change Location and try again.
Error 2: DJI Phantom 4 Battery Error.
Usually, DJI Phantom 4 battery error pops because of an imbalance in battery cells, faulty power management board, and battery firmware glitches.
Solutions.
- Refresh battery firmware. Update Phantom 4 firmware while keeping the glitched battery inside. Read How to Update DJI Phantom 4 firmware.
- Drain the battery to zero and recharge it fully.
- Change the battery.
- Change power management board. If the error still exists, the power management board might be glitched or damaged. So you would have to change the power management board. Advisable to contact DJI Support.
Error 3: DJI Phantom 4 ESC Status Error.
Usually, ESC status error can be caused by outdated firmware and faulty electronic speed controller (ESC).
Solutions.
- Update Phantom 4 firmware.
- Replace ESC.
Error 4: DJI Phantom 4 Compass Error (COMPASS-ERR).
In most cases, Phantom 4 Compass Error pops up because of placing and flying the aircraft near a magnetic field. Once the aircraft is placed near a magnetic field, it assumes the artificial magnetic field as the earth’s natural magnetic field. Then it pops “Compass Error” when the Phantom 4 checks its orientation against its GPS position and finds a discrepancy.
Solutions.
- Avoid Electromagnetic interference. Fly the Phantom 4 away from powerlines, communication towers, huge buildings, etc.
- Calibrate the compass in an open wide area. Move away from the place where you currently receive Compass Error to an open area. Then perform a proper compass calibration on Phantom 4. Read how to calibrate the compass.
- Contact DJI. If you still get the error, it’s better to contact DJI for repair.
Error 5: DJI Phantom 4 GPS Error.
DJI Phantom 4 GPS Error is usually caused by firmware issues, DJI GO 4 app issues, miscalibrated compass, and GPS module glitches.
Solutions.
- Update DJI GO 4 app to the latest version. Visit DJI Downloads Center and download and install the latest DJI GO 4 app.
- Update or refresh Phantom 4 firmware. Read How to Update DJI Phantom 4 firmware.
- Calibrate Phantom 4 compass.
- Replace the GPS module. If you still facing the issue, the GPS module might be glitched or damaged. So you need to replace this. Better to contact DJI to replace or fix the issue.
Read More About GPS Error: Drone Won’t Connect to GPS & GPS Errors.
Error 6: DJI Phantom 4 Camera Sensor Error.
In most cases, DJI Phantom 4 does not show any camera view and pops camera sensor error, chances are the ribbon cable to the camera is damaged.
Solution.
- Replace the Camera ribbon cable. Buy Phantom 4/ 4 Pro Ribbon cable for about 40$ and replace the current ribbon cable. Here is a demonstation video from the youtube.
